Is there a difference between "pulling the knob" which applies force down the length of the bat and "torquing the handle", which rotates the barrel about pivot point, in your mind?
Original Post
Replies sorted oldest to newest
I detect you "got the picture", Jake.
And I detect BM did also.
As both of you now take a few steps back.....off the box concept.
Now, it's "well....you don't do it through out the entire swing".
Soon it will be....you don't do it at all.
Careful who you listen to Jake.
Box maintenance is a direct cause of bat drag AND spinning.
Mark my word, Jake.
And I detect BM did also.
As both of you now take a few steps back.....off the box concept.
Now, it's "well....you don't do it through out the entire swing".
Soon it will be....you don't do it at all.
Careful who you listen to Jake.
Box maintenance is a direct cause of bat drag AND spinning.
Mark my word, Jake.
quote:Originally posted by Loose Cannon:
I detect you "got the picture", Jake.
And I detect BM did also.
As both of you now take a few steps back.....off the box concept.
Now, it's "well....you don't do it through out the entire swing".
Soon it will be....you don't do it at all.
Careful who you listen to Jake.
Box maintenance is a direct cause of bat drag AND spinning.
Mark my word, Jake.
gee i thougt it was try to maintain the box till contact? now its just start the box intact? I would say the heck with the box..not a good cue
quote:Soon it will be....you don't do it at all.
Will it get to this?????....Oh my!
